Please read these instructions from beginning to end before you start the installation. Should you have any questions, please contact SportbikeEffects immediately. If you do not feel comfortable doing this job yourself, it is suggested that you have an experienced Motorcycle Technician perform the installation.

1. Remove the 2 seats, the 2 grab bars, the tail section and tail light.

2. CUTTING OF THE UNDERTRAY. IMPORTANT NOTE: The following procedure involves some cutting of plastic. Use Safety Glasses for all cutting and/or grinding procedures! There are two ways to cut the undertray. You can do it while it is still installed in the bike, or remove it and do the cutting on a table. I suggest doing the cutting with the under tray on a table. If you do elect to remove the under tray, you will have to remove the battery and all electrical components from the under tray. If you do decide to leave the under tray in the bike, be very careful and watch for any wires in the area where you have to cut.  You can do the cutting with a Dremel tool, a good utility knife or a small saw. The under tray, after it is cut, looks like the example in the four pictures below. The pictures are of a ZX-9R under tray, but is very similar to the ZX-6R.