There is a "bump" located at the bottom front of the stock Turn signal stock hole. Please see the picture below.

Because of this there is a small modification that must be done in order to use the Mototeck Flushmount on these models of Kawasaki.

1. Remove the stock Turn signals.

2. Cut the plug from the stock Turn signal to use with the new Flushmounts.

3. Use a Dremel tool with a Sanding drum attached to remove the "bump", and no more. See the picture below:

4. Install the Flushmounts referring to the Installation Guide for the Flushmounts. Don't forget to use some masking tape for a marker to line things up.

© 2005 Sportbike Effects.com