|
|
|
2. Using the screw driver shaft, pry the rubber plug out of the handlebar as pictured below. NOTE: Alcohol when spayed on rubber acts as a lubricant and will dry quickly without residue. |
|
|
|
3. Remove the bolt and the rubber plug from the stock bar end and place it on the Mototeck Bar End as shown below. |
|
|
|
4. Install the new Bar End Weight into the Handlebar so the depth of the rubber plug is as it was before it was removed. Use Alcohol as a lubricant if necessary. Tighten the mounting screw as required. |
|
|
|
|
