These Instructions are for all 2 wire, Mototeck Flushmount turn signals. If you have the three wire signals, that have the additional functionality to be used as Running Lights, you need to get the specific Installation Guide for the product that you have.

1. First, remove the stock flashers.

2. Clean the body in the area where the new blinkers will be installed. Be sure to remove wax and grease if there is any.

3. Take the flush mount and without removing the backing tape, put it on the side panel to center it Use masking tape for markers to make sure you will apply it at the same spot.

4. When you are sure of where you're going to install it and have actually installed the masking tape markers, then remove the red backing tape from the rear of the blinker.

5. I suggest using a hot hair dryer or heat gun to heat up the area of the double sided backing tape, and the area where it will sit on the bodywork.

6. Once the blinker is installed, you can make the connections from the back. Remember, these lights are blinkers only (not running lights), so the blue wire (on a Yamaha) will not be used anymore unless your blinkers are designed to be running lights

7. Remove the masking tape you have used for a marker guide.

*Note*
If for any reason, you need to remove the blinker from the body panel, you WILL need new double sided tape. The old tape will NOT be good anymore. You can buy the double sided tape at any Auto Parts store, such as
Kragen, Grand Auto, or similar Auto Parts stores.

© 2004 Sportbike Effects.com